6/8 Toyota 22RE Engine / Starter and Command Box extension

thingiverse

This is a Custom-Made Starter Box for the 22RE Toyota Engine https://www.thingiverse.com/thing:644933 My completed project can be viewed at https://www.thingiverse.com/make:692499 # Print Settings 1 x StarterBody1 : Layer:0.15mm Raft:no Support:no Infill:100% 1 x StarterBody2 : Layer:0.15mm Raft:no Support:no Infill:100% 1 x StarterBody3 : Layer:0.15mm Raft:no Support:no Infill:100% 1 x StarterSolenoid1 : Layer:0.15mm Raft:no Support:no Infill:100% 1 x StarterSolenoid2 : Layer:0.15mm Raft:no Support:no Infill:100% 2 x StarterConnector : Layer:0.15mm Raft:no Support:no Infill:100% 1 x StarterCommandBody : Layer:0.15mm Raft:no Support:yes Infill:100% 1 x StarterCommandDoor : Layer:0.15mm Raft:no Support:yes Infill:100% 1 x StarterCommandGasket : Layer:0.15mm Raft:no Support:no Infill:100% 1 x StarterCommandHubcap : Layer:0.15mm Raft:no Support:no Infill:100% # Accessories 2 x m3x5mm SHCS 4 x m2x10mm SHCS 8 x m2x5mm SHCS 4 x m2 jam nut 1 x Electric Motor https://www.amazon.com/dp/B07RRPS7CC/ 1 x Speed Controller : https://www.amazon.com/dp/B07K2S9VRY/ 1 x Braided Sheath : https://www.amazon.com/dp/B07F8YRY3T/ 1 x Female Jack : https://www.amazon.com/dp/B07TNDKY7V/ # Mounting /!\ Before installing the starter, fix the Electric Motor to the Electric Drive. I used this one: https://www.thingiverse.com/thing:2233507 Mount the StarterBody1 to the Electric Drive with m3 screws. Insert the StarterBody2 into the StarterBody1; you can glue it or attach it with m2x10mm screws (view the pictures; make holes for them). Attach the first StarterConnector to the StarterBody3. Connect the wires to the Electric Motor and run them through the hole of the StarterBody3's StarterConnector. Insert the StarterBody3 onto the StarterBody2; you can glue it or attach it with m2 screws (view the pictures; make holes for them). Be careful not to pull on the wires. Attach the second StarterConnector to the StarterCommandBody (hole on left side). Mount the StarterCommandBody to the engine block with m3 screws; the holes of the engine block already exist (look at the picture). Insert the electric wires into the Braided Sheath and insert it into the StarterCommandBody; then fix them to the Speed Controller. Be careful with polarity. Connect the Female Jack to the Speed Controller; once the Female Jack is mounted on the StarterCommandDoor, the wires should be long enough for easy opening and closing. Be careful with polarity. Mount the Speed Controller with m2x5mm screws and m2 jam nuts into the StarterCommandBody; it's the most delicate part. Mount the Female Jack to the StarterCommandDoor; if necessary, glue the StarterCommandHubcap around the head of Female Jack (look at the picture). Mount the StarterCommandDoor and StarterCommandGasket onto the StarterCommandBody with m2x5mm screws.