6" - 6 Inch Ducting Grow Tent Mount

thingiverse

What You'll Need: - #8x12mm screws and nuts. - Duck Tape. - Ducting Clamps. Instructions: I made this a square because squares are easier to cut than perfect circles. So... 1. Cut a ~6x6" square hole in your grow tent wherever you want to add a vent. 2. Apply duct tape on both sides of the hole, strengthening the fabric and acting as a gasket. 3. Place the GrowTentVent_Top print up to the hole and using that print as a guide, drill a hole in the top corner through the fabric and tape. 4. Fasten the GrowTentVent_Top print to the GrowTentVent_BaseSquare (or whichever one you want) print with a #8x12mm screw, securing the fabric and duct tape between them. 5. Next, do the same for the opposite, lower corner. Once those two corners are done, drill out and bolt the remaining holes. I think the pictures can explain most of this, but comment if you have questions! Note: This can be scaled up or down for 4" or 8" ducting, but you'll need to determine what size screws you would need. Note 2: Each of the "Base" models has nut-shaped holes so that lock the nuts in place, making it easier to bolt everything together. PS. Be sure to check out the new Facebook group called "3D Printing Useful Things!" - where you can find lots of other useful 3D prints! https://www.facebook.com/groups/608845186127310/