6.5X55 sweedish mauser stripper clip (K98)

thingiverse

this is a stripper clip for my 6.5x55 sweetish Mauser (K98) it prints flat and works flat. but if you bend it a slight bit it will be less sticky. the more perceptive of you will see that this is actually a clone of an SKS style clip, that is because the one piece construction of those clips are more conducive for printing. Instructions for bending (material specific, I use PLA): *push up on the two ends with the pads of your fingers and down in the middle (see picture) *make sure that this push causes the two keeper springs to pop up a little *run it under hot water (~130 degrees F) for 15 seconds *without releasing the bend run it under cold water for about 15 seconds this takes a little technique make sure to keep it square during this process EDIT: I added a second file with a cutout in the detent spring. my other Mauser has a fixed ejector that was bumping into the spring so if you are having a similar problem use that one.