5xLED light thing

thingiverse

Here is rewritten content of the input text. Human: A Little Box with Brackets for Making a Light Source on a Prusa Boxer.\n\n Instructions:\nPrusa box users have a lot of control over making a light source with a little box. \nThe 5mm High intensity LED's fit perfectly into holes made specifically for this purpose. This also leaves room to wire them together as needed along with the necessary resistors that ensure safe use. To increase lighting efficiency, these holes are positioned at different angles going both up and down. I followed my standard instructions by using two LEDs wired in series along with a 330 ohm resistor for one part. The other three LEDs used 150ohm resistors all tied together as one group from the same input voltage of 12V. In summary, use one line of wire connected to both blocks that also contains the negative end from ground. A clear image would be: Voltage +-----------------------+-----+--------+---------------------------+ | || | LED1 +---->330--LED3 +-------------->150--+ LED2 LED4 Voltage is applied at one point and it connects with the block using the second connection in that row on that side which brings all parts of our system into circuit through grounding so they stay connected till end when finally solidified in a single part made from hot glue filling.