5s (5mm w/mouse ears)

thingiverse

Instructions for Assembling Customized Smartphone Case: Using the following settings: - Stencil Pattern Element Overlap: Disabled - Left Port Corner Resolution: Set to High (8) - Top Outer Edge Chamfer Radius: .6 units - Wall Thickness of Custom Case: 1.6 mm - Rounded Corners: Applied, radius set to 10 - Rear Camera X-Dimension: Increased to 20 - Top Port's X-Position on the Front: Adjusted to -10 - Stencil Rotation: 0 degrees - Phone Body Thickness: 10 mm - Rear Camera's Y-Position: Reset to Original (0) - Stencil Vertical Position: Elevated, .6 units from top - Length of Left Port on Custom Case: Increased to 50 units - Line Width for Pattern Elements in the Stencil: Enhanced (30) - Chamfer Radius at Top Inner Edge: Applied, set to .6 units - Overhang Fillet Resolution: Set Low (2) - Tolerance Value for Printing Precision: Set at 0.35 mm - Rotation of Pattern Elements in Stencil: Kept unchanged (0 degrees) - Custom Bottom Edge Chamfer Radius: Adjusted to .6 units - Additional Space Provided Between Ports on Rear: Increased by 30 units - Enable Overlap between Pattern Elements: Disabled - Positioning for Horizontal Element within the Stencil: Aligned at middle (.5 units) - Radius for Inner Edge of Lower Port on Case: Adjusted to 1.6 mm - Custom Pattern Thickness on Case Body: Set low, .8 units - Top Port Corner Resolution: Upgraded to High (8) - Detail and Resolution of Corners: Applied at high, 8 resolution units - Radius for Bottom Port's Inner Edge: Changed to 5