5mm LED doide holder

thingiverse

My brother-in-law was making a computer desk for his girlfriend, so I jumped in to help him out. We decided that adding underlights would give it a fantastic finish, so we made it happen. It's going to be super useful later too. Now let's get into the print settings. Printer Brand is Printrbot. I used their Simple Black printer. I set Rafts to Yes because that seemed right for this project. Supports aren't an issue in this case. Resolution was dialed up to High, which produced a nice finish. For Infill, 25 worked perfectly fine. Finally, here are some Notes. Since the prints were quite big, I slowed my printer down by setting feedrate to 70% in Repetier. This let me get ten pieces printed in just twenty minutes while they lay flat on the work surface.