54 theeth T2.5

thingiverse

This customized object is based on the thing at http://www.thingiverse.com/thing:16627, and was created using the Customizer app with an input thing ID of 16627. To print this design, you can use the following settings: retainer height (retainer_ht) of 1.5; an idler of 1; a motor shaft diameter (motor_shaft) of 6; tooth height of pulleys T (pulley_t_ht) at 12; no additional tooth depth (additional_tooth_depth) is required; two nuts (no_of_nuts) are needed with a flat diameter (m3_nut_flats) of 5.7 and a diameter (m3_dia) of 3.2, each at an angle (nut_angle) of 180 degrees; the profile is set to 5; retainers are included (retainer = 1); idler height (idler_ht) is also 1.5; nuts have a depth (m3_nut_depth) of 2.7, a shaft distance (nut_shaft_distance) of 4 from the nut angle; pulley B has a height (pulley_b_ht) of 8 and diameter (pulley_b_dia) of 35; the hex depth for m3 nuts (m3_nut_hex) is 1; and finally, there are 54 teeth in total with an additional tooth width (additional_tooth_width) of 0.2.