52mm Goblin Knight Charging on Giant Wolf

thingiverse

Adventurous humans raiding your dungeon, plundering your stash? Time to call in a Goblin Knight to put the hurt on them, run their lives through, and pike their heads at the entrance of your lair. This 3D model is tailored for high-impact polyethylene-based plastic printing. One of five yet-to-be-completed wolf riders, it's just one part of an epic design still in development. For print settings, visit our blog or follow instructions below. 28mm-scale model versions available at timeportalgames.com, also accessible via Shapeways shopping cart. **Important:** Some assembly required, a fine blade and superglue needed for joining figure to its armament and shield. Settings for slicing include: Layer height: Keep it thin - between .15mm. Support density: 1-1.5mm should be enough. Infill Density: Choose anything at or above 40%. Need more? We've got loads of free designs up on our website timeportalgames.com. --- **Assembly Guide:** For dual extrude mode and HIPS printing: Temperature set to 230. 25% fill on the wolf and anywhere between 40-70% fill for the goblin, with all else set at 50 feed rate. For more specifics follow print guidelines online