50mm STI Reverse Lockout Shift Knob Remix

thingiverse

FILE RECOMMENDED FOR FDM:\r\nPlease use the adjusted sleeve files when printing with an FDM printer. They generally allow the nut to slip in better and put less stress on the part. The other adjusted parts may work as well, but they usually aren't as easy to use. Thanks for downloading! UPDATE Shrinkage became a problem when making this project on FDM printers. New models have been added as a result. The sleeve-adjusted models have an additional 0.4mm added to the diameter of the hex nut of the already adjusted models for ease of installation, but may require epoxy when printing. The plainly adjusted models however are built with a 1 mm adjustment to allow for shrinkage not to be an issue. Please use either of these shrink-adjusted top and bottom files for better results and easier assembly if using a FDM printer. If you want a 60mm version instead of a 50mm version of this, please go to my other design here: https://www.thingiverse.com/thing:2467630 This is the smaller version of a previous design that I based off of the remix of the WRX Shift Knob originally created by WillsWorld and remixed by Dingoboy71. This design incorporates the reverse lockout design meant for STIs while being at a 50mm diameter. I used Fusion 360 as well as hand measurements off of the original print to redesign this by handing customize it to my liking. Changes: Changed the logo to be the STI logo and altered the position of the hex nut to be between both the top and bottom pieces to improve strength. Purchase the required hardware below and put it together! Hardware Required: (1) M12 x 1.25 thread pitch Nylock nut. (6) M3 x 20 (or 25) mm hex bolts (6) M3 x .5mm Nylock nuts (1) Tube of super glue or epoxy. Nylock nuts recommended by Dingoboy71 are preferred, as he states that Loc-Tite may permanently weld it to your car if the wrong variant is chosen.