50mm Rotating Spool Holder - Remix

thingiverse

Redrawn remix of the 50mm Rotating Spool Holder - https://www.thingiverse.com/thing:119016 Uses Spool Holder Mount and Spool Holder Clips from the Ultimate 50mm Rotating Spool Holder - MakerBot Replicator 2 (119016). Also requires: 1 - A hex head bolt measuring 5/16" x 4". 1 - A nylon lock nut measuring 5/15". 2 - Two washers with a diameter of 5/16". Changes from the original design include: 1. Increased length, accommodating wider spools up to 100mm in diameter. 2. More clip holes for varying width of spools. 3. Offset half of the clip holes, allowing for greater flexibility on clip placement. 4. A wider flange with a diameter of 70mm to accommodate larger spool holes. 5. The shaft holder is recessed to allow the spool holder to sit closer against the Replicator 2. 6. A solid design replaces the geometry with rib supports, which were weird with the offset clip holes. Print settings: Three shells 15% infill Print with flange on print bed Update: Version 2 has a deeper well for the lock nut.