5015 Fan Top Fits Mk3(s)

thingiverse

I had to print a replacement because over-tightening the bolt makes it easy to crack where it goes in. I shared this design since there is another thingiverse with a complete blower, but it didn't line up properly for me. This was my third attempt at guessing and printing 10% then matching up pieces. Luckily, it fits and will work when bolting on, although you might want to line it up once the bolts are snug because it's slightly too small on one side by about 1mm. I added a bevel so the fan wouldn't get stuck or rub against anything. The fan spins freely with this part installed. It's not perfect, but like I said, it will fit the fan on the mk3s and probably other 5015's. If there's a need for improvement, I'll remix the design. Thanks for reading, hopefully this helps someone.