5015 Blower Fan Aquila S2 Dual Blower Fan Shroud

thingiverse

Non-printed items: 4x M3x20mm. (To install the 5015 Blower Fans to the support) 4x M3x12mm. (To install the Blower Fans Supports to the shroud) 8x M3 Nuts. 2x 5015 Blower Fan. 1x Noctua NF-A4x20. DISPLAY EXTENDER ONLY: 2x M3x12mm. 2x M3 Nuts. Assembly instructions: NOTE: 1 - The instructions will include only the shroud and blower fan arms. The instructions won't say how to install the fans. There are a lot of videos on youtube about how to install them on the motherboard. 2 - To install the Front_Fan_Cover use the screws that come with the fan you buy. The instructions are straightforward. 1 - Remove the original shroud. 2 - Remove the original fans 3 - Install BL_Shroud_Aquila_S2. This should be plug-and-play. Use the same screws that the original shroud uses. 4 - Install the right and left arm blower fan. (4x M3x12mm and 4x M3 Nuts required). 5 - Install the rest of the accessories (Fans and BL Touch). Display extender: This part can be printed if the Front Fan Cover hits the display when creating the auto-levelling mesh. To install, follow these instructions: 1 - Remove the display support from the printer. 2 - Remove the display from the support. 3 - Install the display extender to the display support. (2x M3x12mm and 2x M3 Nuts required). 3.1 - Check the image to see the installation orientation. Top´= face where touch the display. Left = side where to mount the extender on the display support. 4 - Install the display on the extender. (Use the original screws that attach the display to the support). 5 - Install the display support to the printer.