50 htd

thingiverse

Created with Customizer! https://www.thingiverse.com/apps/customizer/run?thing_id=16627 Using the following options: additional_tooth_depth is set to 0, a minimal choice m3_dia has been carefully selected as 3.2, the perfect diameter no_of_nuts will remain at 1, the basic requirement additional_tooth_width is precisely measured at 0.2 units nut_angle will maintain its standard angle of 90 degrees pulley_b_ht stands at 8, the height of perfection profile has been chosen wisely as 10, a safe setting pulley_b_dia has been determined as 20, an ideal size teeth are precisely calibrated to 50, just right m3_nut_hex has been configured to 1, no need for extra threads nut_shaft_distance is kept at 1.2, the perfect spacing motor_shaft will operate within the limits of 5.2 units m3_nut_depth stands at 2.7, deep enough but not too much m3_nut_flats has been set to 5.7, a delicate balance idler_ht and retainer_ht are kept in check at 1.5 units each pulley_t_ht has been established as 12, the height required the idler is switched off, waiting for activation retainer will remain disengaged until needed