5$ Leopard Imprint Litophane Lamp

prusaprinters

READ THE DESCRIPTION!NO SUPPORTS NEEDED! Softwares used: Litophanemaker.com / Meshmixer / SolidworksYou need to buy the following lamp which costs approximately 5$ from the store “Jumbo”. Materials:I used PLA and that's okay but only use it with LED lamps! Because of the temperature. I used Marble color but I suggest you using just white. It would be better for a litophane.Settings used:No supportsInfill: 10%Layer height: 0.2  but you can go lowerPerimeters: 2Speed perimeters: 45mm/sSmall perimeters: 25mm/sBridges: 20mm/sIf you want to create something similar I used the following settings on litophanemaker.com:Litophane parametersLithophane Resolution (mm/pixel): 0.3Top Diameter (mm): 125Bottom Diameter (mm): 155Number of Half-Waves: 0Size of Waves (mm): IrrelevantHeight (mm): 130Base Width and Height (mm): 4Overhang Angle (deg): 45Maximum Thickness (mm): 1.2Minimum Thickness (mm): 0.4Spacing Between Pictures (mm): 0 Spacing Brightness [0-1]: 1 Frame OptionsClamp Interface Ledge Interface Ledge Diameter (mm): 37.2Ledge Height (mm): 30Cylinder Diameter (mm): 79.5Cylinder and Ledge Thickness (mm): 4Spoke ParametersSpoke Thickness (mm): 4Spoke Depth (mm): 4 Texture used: If you are using the same lamp, you need to create a cylinder in the middle of the ledge with an inner diameter of 37.2mm and an outer diameter of 46.8mm. This cylinder eliminates the need for support and allows the lampshade to be snapped into place.