5.5" Rocket Popper w/ Rattle / Weight Provision Striper fishing lure

thingiverse

This popper is 5.5 inches long, 1 inch wide, and features 13mm flat openings for self-adhesive or glue-in eyes. It also has provisions for grommets in each opening, as well as a hole through the center for a stainless steel wire. A 1-inch by 0.368-inch section can be added to add weight or create a rattle, with BBs or pellets working exceptionally well. Note that the more weight used, the less infill is required to keep it floating, and the pause height to add weight is around layer 265. Don't forget to tip if you can; I appreciate your generosity in advance. Thank you! PLA printed at 20% grid infill weighs approximately 1.25 ounces without any rigging or weight added. PETG printed at the same setting weighs about 1.5 ounces with a 1/8-ounce shot, and no additional rigging is required. Good luck, and tight lines! Update: I've finally found some time to test one out - in August 2019, I caught a schoolie striper, which was just one of many on that great day.