4x4 Logo Badge

thingiverse

Have some fun with friends who drive 4x4’s and at the same time help people with their mathematics. Yes, 4 multiplied by 4 equals 16, or using numbers 4x4=16, just do the maths. Some people are clever enough to figure this out by themselves, whilst others need assistance with this equation and just need a little reminder. The logo is 25mm high and 5mm thick, and may be scaled to your requirements. Compared to the v01 version, the v02 version has sharper corner radii, a second bevel on the sides and a deeper hole in the “6”. For best results, print the logo with a resin printer. However, if printing with a filament printer, print the logo with at least 20% infill. Use filler and lightly sand the model to remove layer lines and other imperfections. Paint the logo using good quality chrome enamel paint. Attach the logo to your friend’s vehicle using magnetic sheeting, otherwise they may become slightly upset. Ideally recycle a fridge magnet that is no longer needed, perhaps one displaying last year’s calendar from your really friendly local real-estate agent or politician. Use double-sided tape to apply the magnetic sheet to the rear of the logo and trim around the edges. Use double-sided tape for permanent attachment to your own vehicle. The 4x4 logo was modelled in ViaCAD and cleaned up in ZBrush.