4x2-Pegboard Wizard

thingiverse

This thing was made on the Customizer! Go to www.thingiverse.com/apps/customizer/run?thing_id=537516 Options were chosen like this: Holder count in X-direction is 4 The bottom part isn't closed down. The holder strength is a 0.66 factor Radius of corner is 30 The thickness of the wall is 1.85 millimeters thick. The height of holder is twenty millimeters high There is no holder cutout on this side Holder has been offset zero point zero mm away from default spot Width of X-holder dimensions is 20 mm across The angle for this piece hasn't changed one single degree yet Count of holder in Y-direction number is two Taper ratio stands at 0.75 to be exact. This width was determined to be twenty millimeters in overall size This angle is at zero degrees now too.