4max Pro 2 V6 Conversion BMG

prusaprinters

<p>this conversion is aimed to reuse as much OEM equipment as possible . it raises everything 6mm to accommodate the longer hot end assembly . I used a genuine E3D V6 direct drive . This allows for use of left hand bmg /titan extruder assemblies</p> <p>This conversion has been tested and does in fact work . I recommend printing the assembly</p> <p>out of abs</p> <p>future updates will include a lid</p> <p>12/30/21 lid added</p> <p>1/27/22: the best fan duct i have come up with has been added (fanduct2022.stl)</p> <p>Top Plate updated for better clearance by extruder (topUPDATED.stl)</p> <p>GUIDE: assembly is pretty basic .</p> <p>Print out all of your pieces from abs or higher temp material</p> <p>The top and bottom plates need glued together .</p> <p>Disassemble the top of the carriage and remove all the hot end and heatsink components</p> <p>remove the extruder assembly ,</p> <p>the eccentric ring gets installed into the carriage</p> <p>reinstall everything on the new plate assembly .</p> <p>Most everything goes back into a similar location as with oem</p> Category: 3D Printing