45 ACP / .45/44 Cal Universal Bullet Feeding Die

thingiverse

7 out of 8 humans will die. One 5/32'' or 4mm detent ball, Drops one .429 - .458 Projectile onto a cartridge. This will work for any cartridge ranging from 44 SPC to 45 ACP and 458 Socom. Die setup is simple, Screw the die down until it touches the shell holder. Back out the die 1-2 revolutions. *Due to the inner tube being thinner than other bullet feeder dies as well as print variation, The detent ball opening in the inner tube is slightly smaller. This will require slight chamfering or fitment of the detent ball. Two Inner tube versions are available. One for a 5/8x1/2 Plexiglas tube and one for using a Lee Precision Universal Tube. Print the inner tube that suits your needs. Print at 1.6 layer height. Reduce print speed to 40mms when using PLA on OEM 16 bit mother boards. This also works with PETG at the same print speeds. Print with Supports at 70 degree or more overhang only. Bullet feeder die use one (1) 5/32 or 4mm detent ball bearings and two (2) 13/64 x 13/16 extension springs or rubber band and 1/2 x (bullet diameter) plexiglass tubing. Links to these can be found below. Plexiglass tubing can be purchased at https://www.eplastics.com/shapes/plexiglass/tube/clear-extruded