40cm rolling pin/ Nudelholz
thingiverse
I made a creation using 3D printing because I could. It's a large rolling pin, with a 40cm long and 8cm wide roller. The handles are attached to an axle inside the roll, allowing for full operation. To connect them properly, some filing was necessary. Instructions: To assemble, you'll need: * 2x half roller pieces * 1x roller connector For the handles/axle assembly: * 2x grip handles * 1x double-nipple rod * 2x extension rods It's recommended to print the half roller piece with a thicker outer shell, like 3mm, and about 22% infill for added stability. If you're after high-quality prints, I suggest printing in 100µm steps at around 50mm/s - this can take nearly a week, but yields a very round surface. Once the pieces are assembled, pay close attention to the alignment of the rods. With a little patience and the right amount of glue, your rolling pin will be ready for use.
With this file you will be able to print 40cm rolling pin/ Nudelholz with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on 40cm rolling pin/ Nudelholz.