4010 long fan duct for E3D V6 Clone

thingiverse

I created this duct for four key reasons: 1) The fan that came with the hot end was far too loud. 2) A replacement 2010 fan is significantly more expensive than a 4010 fan. 3) The existing fan duct and fan housing broke when installing, causing it to rattle even more. 4) I needed a longer tunnel due to my X-Carriage setup. This duct is designed for a clone hot end, specifically the Dophee E3D V6 3D Printer J-head Hotend Bowden Extruder for 1.75mm 0.4mm Filament: https://www.amazon.ca/gp/product/B01M8QCKQF/ref=oh_aui_detailpage_o06_s00?ie=UTF8&psc=1 The duct fits comfortably and snugly, but I've included an opening for a zip tie in case you want to tighten it down. I've also included a measurement drawing so you can see if it will fit on your setup before printing. Enjoy using this duct.