4 Mangekyou sharingan (Sasuke, Itachi, Kakashi, Izuna, Shisui)

cults3d

It is a keychain that is printed in 2 parts. the first part consists of the circle and the second part consists of the black blades. It should not be printed with supports either of the two parts, are made to be printed without the need for any support, but to look good should be printed at a relatively slow speed. then I will put the parameters you use. To get the black blades inside the circle should be with light pressure, not too hard so it does not break. Note: it is advisable to wait for the hot bed to cool down and then remove the blade part to avoid deformation, as it is a relatively thin part. Sometimes it is advisable to sand the blades a little before putting it in the circle to eliminate imperfections and to allow it to rotate better.