4 inch fredstyle drone

thingiverse

This is my 4-inch fpv frame. I employed a 20x20 fc. I possess two frames: - one with standoffs printed directly onto the frame, securing the fc using small servo screws - and another frame featuring four holes for utilizing m2 standoffs to secure the fc The only problem lies in the hole intended for the usb cable insertion, which isn't correct; therefore, print 4 extra standoffs in place of those on the left and right sides. Motors: I utilized 2204 2300kv motors. I believe this setup is not ideal for a 4-inch frame but I used what I had available. Camera: The camera that I employed is a 25 mw cam from my old Blade Inductrix fpv, accompanied by an STL of my top plate minus the mounting holes for the VTX and an editable DXF file as well. I created three versions of camera holders: 0°, 10°, and 20°. I opted for the 10° version because I wanted to fly in tight spaces without needing a lot of camera tilt. The lens hole is 10mm. Screws: - 8 x m3 x 30 mm Countersunk Screws - 8 x m3 nuts Have fun building and flying it yourself! Flight video: https://youtu.be/vvNtetmpWBw Build video: https://youtu.be/UYirvCw0TGo