4 INCH CYCLONE SEPARATOR VERS 2021

cults3d

4 INCH CYCLONE SEPARATOR VERS 2021 IN ORDER TO AVOID ANY PROBLEMS DURING PRINTING - ON THE FRONT THREAD, I DECIDED TO DESIGN A BOLTED CONNECTION! IT REQUIRED 4 SETS M6x20-25 HEX BOLT + NUT. DO NOT OVERTIGHTEN! USE A GASKET SEALANT BETWEEN FACES (ON BOLTED CONNECTION ONLY!) THIS UNIT USE A DOUBLE THREAD DESIGN, CREATED AND OPTIMISED FOR 3D PRINTING. ARE FEW VARIATIONS OF THE DESIGN, THE "BIGGER/LONGER" THE BETTER, HOWEVER MAKE A BALANCE BETWEEN COST OF THE PRINT AND RANDAMENT OF SEPARATION! CLEAN THE THREAD FROM ANY PRINT GLITCHES BEFORE ASSEMBLING! DO NOT REQUIRE SUPPORT DURING PRINTING OF PARTS, IF ASA OR ABS FILAMENT IS USED, I STRONGLY RECOMMEND PRINTING INTO AN ENCLOSED SPACE, IN ORDER TO AVOID ANY WARP OR DELAMINATION. DO NOT REMOVE PART FROM THE ENCLOSURE IMMEDIATELY AFTER COMPLETION, LET IT COOL DOWN SLOWLY! IF YOU ENCOUNTER ANY PROBLEM WITH THIS PRINT, PLEASE LET ME KNOW AND WE WILL TRY TO FIX IT TOGETHER! GOOD LUCK AND HAPPY PRINTING! DESIGN TO PRINT WITHOUT SUPPORT! BY COSTA