3x3x3 Speed Cube

thingiverse

Speedcube V0.71 The goal is to design a Speed-Cube that prints perfectly in PLA / PETG / ABS etc. The spring was harder than expected, however. At this point, you will need to find six springs. Assembled, the cube measures 45x45x45mm. It's recommended to print the pieces as they appear, especially the mid-piece! I designed it for 0.2 resolution but recommend 0.1 instead. To assemble the cube, you'll need: Center-pieces: Six of them Corner-pieces: Eight in total Mid-pieces: Twelve parts to be printed Lockers: Six pieces required Frame: One piece to hold everything together Caps: Eight of your choice for each of the six sides. The center and locker serve as the ninth. Non-printable parts include: Springs: Six of them, approximately 5-10mm long and 5-8 mm in diameter. Good to know: When assembling the cube for the first time, start by pushing each locker onto each leg of the frame and turn it clockwise 90º. Otherwise, it may be difficult to get everything in place with the centerpiece and spring. If it's too tight a fit due to the first layer, try turning the cube upside down with the "+"-side facing up (the diameter is slightly larger on this side). Don't attempt to lock anything; simply push it straight down with the two dots on the locker aligned with the channels on the frame.