3rd Doctor TARDIS Console Room The Time Monster 5.5 Inch Scale

thingiverse

I am currently in the process of testing this print. You will need: 1x All files except for "Door Hinge" and "Door Wall Peg." Door Hinge x4 Door Wall Peg x2 Many 6mmx30mm wooden dowels Metallic mesh with small holes/Lenticular plastic/Semi-transparent light grey shower curtain Recommended print settings: 10-15% infill, 0.15mm layer height. To assemble, simply shove the dowels into the holes. They may need to be forced with a hammer, but they should go in quite easily. Make sure not to print with supports on when it can be avoided, as it can end up putting the supports inside the holes. The "Door Wall Pegs" should go into the very narrow holes of the door wall, as the gaps between roundels would be too small for a dowel. The pegs may need to be sanded slightly to fit. The backings behind the roundels appear to have been made out of a dark lenticular plastic, but the video quality is too low to tell. It may simply be a type of metal grate in front of the usual transparent sheet, but it's incredibly hard to make it out. In any case, Cut the mesh, plastic, or shower curtain to fit the walls, then simply adhere it on the back of the walls. Place the doors on top of the portusions on the door wall, then drop the door hinges inside them. Almost every part of the console room is the same ever-so-slightly-off-white color. Simply spray painting it is probably easiest. The bowls are glossy while the walls are matte, so hand painting a semi-glossy sealant on top of them should give the desired effect (though if you want to be perfectly screen accurate, the bowls seem to be slightly whiter than the walls). The controls on the undersides of the overhangs are varying shades of off-white, cream, and dark grey. The vents themselves are dark grey and the circles are black. The zigzag part of the hallway out of the console room is a medium grey, including the ceiling part with the 3/4ths roundels.