3racing Sakura D5 MC1 type conversion with Yokomo YD2 gearing

thingiverse

You cannot sell these parts based on the license. They are free to use. I have made 3 of these and used them for over a week, the files work. I loaded this as some others were interested in it. You must print at .2mm with support from the build plate on anything over 80 degrees. Don't print at .3mm. Don't over crush your first layer or you will have issues. The spacers for the gear cases are a tight fit to ensure alignment. Assembled the gap between the gear cases is 11.5mm give or take .3mm, usually 11.7-11.5. That is the most important part Install 1mm (5MM ID) spacers on each side of the idler gear. I have made this with a TA06 gear diff or Usukani diff, have not tried with a genuine Yokomo diff, if there is a clearance issue let me know. Parts needed: All Yokomo transmission parts along with the gear carrier and motor plate from a YD2S. Basically you need a complete donor transmission. Yeah Racing YD2 rear carbon shock tower, YKYD-029BK https://www.ebay.com/itm/143326378490?hash=item215eeaf9fa:g:ieoAAOSw5UZfkSTr M3 X 15MM threaded standoff spacers. https://www.amazon.com/dp/B07MQ5L1TS?psc=1&ref=ppx_yo2_dt_b_product_details 5MM spacers for the idler gears, Yokomo PN ZC-S50 (superg has them) Install spacers with M3 X 10-12MM long screws. Fit all parts in one side then install other side of gear case. The only printed holes that are tight are for the 3x15 spacers. The rest fits snug. There are additional files for wiring management. Loaded D5 to yokomo slide rack tom and bottom prints. I used the Reve'd RD-008ST shock tower for this. Lets you install a Yokomo YD2 slide rack. You would shim and set it up exactly like you would in an YD2. This is a very easy conversion. Neither require any mods to the chassis.