3DVK Euro 4 Holes THiNK Remix for Stacking

thingiverse

Updated version of the Euro 4hole remix designed for simplified part stacking with 0.3mm layer height and significantly increased speeds to print 50 pieces in under 24 hours using suggested settings. Usual techniques apply, break off parts with a flat head spanner or a small steel rule preferred. A couple of changes were made to the original file to facilitate stacking: filling in the front part as recommended by Erik Cederberg and adding nubs to the upper surface. Using Prusa Slicer, attempting to stack with an empty layer will fail, so the nubs serve as a workaround and are set at 0.3mm spacing matching the layer gap. Additionally, they enable faster bridging speeds as filament touches and secures on the nubs reducing stray filament. Included STL files for single piece and sets of 5, 10, 15, 20, and 25 pieces. Frames utilize the European 4hole setup identical to the original file; use a 2-hole punch set to 888 (slightly smaller than A6) setting.