3dverkstan 13 stacked .32 mm layer height US 3 hole

thingiverse

Attached is a stacked set of 13 prints completed in just over 6 hours, which equates to approximately half an hour per print. With this stack, I successfully output 100 prints within 24 hours. Extruder temperature: .4 Layer height: .32 Top layers: 4 Bottom layers: 3 Outline shells: 3 or more No support structure is required. Allow single extrusion fill and walls. Infill percentage: 10% It's essential to ensure your layer height is set at .32, as parts won't come apart properly if this setting is not met. To separate the prints, I use a pocket knife. If yours are fusing together and you're using my settings, try lowering your temperature slightly.