3DSets Landy Stock Rack for Model 3

cults3d

Simple to print. I included panels with a wood grain effect but I have not printed any of those yet. The back gate with wood grain will need to print "grain side down". Don't use support, the bridging will be short with minimal effect. I used a small gap to slide over the top rail of the landy read fenders. Those were fairly snug on my Landy. After those are installed use 12 M2X6 screws to hold the front and back to the sides. Now it will be fit to the bed and should not get loose. The gate may need some more tweaks to get the latches correct. My first try was snug and I broke one. I did open those up a little bit on these gates. Looks good to just leave the original Landy gate on as well.