3DFused Pi Cam Mount

thingiverse

I recently acquired the XYZ Linear Rail kits from 3DFused.com and after installation, I found myself in need of a secure spot for my Raspberry Pi Camera to mount, so I modified another design (https://www.thingiverse.com/thing:2886101) to connect seamlessly with the newer X/Y limit switch mount downloadable from 3dfused's website. Since modifications were required for that .stl as well, I've included it in this design. Nothing complicated here. Just print the pieces and give them a thorough clean-up if you're prone to the infamous elephant foot, then they should fit snugly into the switch mount holes. It's also beneficial to use a sharpie to mark where your current switch mount is tightened down before removing it so you can place this one back in the same spot, eliminating the need for readjustments. For the actual camera housing, you have the option of using the original one from the linked thing above or switching to this one (https://www.thingiverse.com/thing:3407867) that I had to use after upgrading my cam's camera module with an autofocus module that sits a bit off center from the original one. Both work perfectly fine with this bracket.