3DFused EZABL Probe Mount for ender 3 pro

thingiverse

I have an EZABL Pro 18mm from th3d on my Ender 3 pro, and it works very well indeed. After installing the 3dfused X&Z AXIS LINEAR RAIL KIT, I ran a test print and the x carriage crashed into the edge of the rail on the right side. The linear rail kit is an excellent addition but the rail on the x axis doesn't allow enough clearance for the probe to function properly. So I designed this mount to accommodate my setup. This probe mount allows for just enough room to have "#define MIN_PROBE_EDGE" set to 30, which is the recommended setting from th3d. Using the stock probe mount provided by th3d, the value had to be 47. This causes the area of the bed covered by the probe to be very small. This is the probe offset -25.7, -47.9, 0 I used. I was able to set it in Marlin without having to reflash the firmware. I haven't long term tested this setup yet, and I'm not sure if having the probe in front of the fan will be problematic over time. This is somewhat a temporary fix for me as I plan to upgrade my hot end eventually.