3Dconnexion SpaceMouse Cover

thingiverse

This is a remarkably thin cover for a SpaceMouse, measuring just 0.8mm in thickness - enough to block out modest lighting, yet still remarkably translucent.\r\n\r\nDust poses no problem with this cover in place, expertly shielding the SpaceMouse from unwanted particles.\r\n\r\nEngineered to fit loosely over the SpaceMouse, it boasts a generous clearance of over 1mm, ensuring a seamless fit every time.\r\n\r\nPrinting this piece is a breeze, thanks to its slender design, which allows for fast and efficient production. For best results, print upside down - unless you're an expert at bridging, in which case feel free to experiment with different techniques.\r\n\r\nA successful print can be achieved by printing the cover open side down, but some stray strands may require trimming afterwards. To minimize this risk, consider scaling up the design by a few percent. Ironing the top surface is highly recommended for a flawless finish that matches the sides perfectly - when printed upside down, it's an effortless and spot-on print every time.