3D Systems Cube3 Cartridge Case Bulkhead; M6 for ABS Printing

thingiverse

I wanted to set this bulkhead on the side because it's tweaked to print with the Cube3 using 3DS ABS. This print is specifically designed to offset errors that these printers exhibit almost universally. Included is the .cube3 for left extruder prints using ABS. For right-side extruder prints, rotate the part along Z by 180 degrees. This works particularly well with "through" M6 fittings some of you may be aware of. It will also work with other M6 threaded fittings. You just need to figure out the feeder tube from the filament driver mechanism. If you use those "through" fittings, the tube between the driver and the fitting would be 98-99MM long with a barrel nut on the tube. Be sure to put back the larger 'overtube' when reassembling the case.