3D Printer Timelaps Remote Shutter for DSLR Camera for Prusa MK3

thingiverse

3D Printer Timelaps Remote Shutter for DSLR Camera specifically made for Prusa MK3 inspred by the design from Filatech. I made a more compact version using a standard micro button. No Tape required to fix the parts. Further to use this stl you need: DSLR Camera IR remote shutter with battery (the clip is for a canon remote shutter I got from ali express which was around 1€) Wires around 30 cm Standard Micro Switch Small piece of bread board you can solder on (I used one with line connections) 2x M2 screws 1x M4 screw To fix the breadboard with the screws you need to drill the holes bigger. I could not find a prefect M4 screw so had to cut it. This setup still lets you do a Z-axis calibration. No double sided tape that might fall off under heat (while printing in an enclosure) UPDATE// This is the custom code I use. ;AFTER_LAYER_CHANGE G90; Absolute Positioning G1 F9000 X250 Y205;Move away from the print G4 S0 ;Wait for move to finish G1 F1000 X251; push trigger G1 F9000 X250; quick release G4 P500 ;Wait for 500ms ;[layer_z] It's important to test and check the X value (251).