3d printer hepa filter holmes aer1 filter with carbon pre-filter

cults3d

Using the following fan: https://www.digikey.com/short/qj7fmv Holmes filter is this one: https://www.amazon.com/gp/product/B00DWHVE62/ref=oh_aui_search_detailpage?ie=UTF8&psc=1 And then any activated carbon pre-filter will do. You'll need to cut it to size, as I couldn't fine anything stock that would fit. I HATE PRINT SUPPORT, SO..... NO PRINT SUPPORT REQUIRED. There are three model here but you only need one. If you're printer will print larger than 250mm then you can print the one piece. Small flange goes on the bed. If not you'll need the two piece. I tried the one symmetrical one piece but my case was in the way and so I had to make the offset one. Pre-filter cage just snaps onto the filter. #6 screws hold it together and I used some light caulk to seal the joints. The slide gate I designed is also located on thingiverse. You'll need to print 8 of the clips. Elbows do not need support if printed in the correct orientation either. There are two elbows . One is symmetrical and short and the other has one side extended an inch or so. Use which ever ones fits with your case. ALL FLANGES ARE COMPATIBLE WITH AN 80MM FAN. The tables I used for my enclosure are a couple of inches larger than the Ikea Lack tables, so be aware of that when building to make sure you have the proper clearance. A lack table enclosure should work, but it's going to be tight depending on how you mount everything. I have a particle counter and from what it picks up there is no change in particle count when I print, which is a good thing. Filter was inspired by another AER1 filter on thingiverse, although mine is an original design and not a remix / modification of that one.