3D printer filament spool holder adjustable

thingiverse

i had my filament attached on my lower part of the printer frame but the spool would wobble when i printed fast so i came up with this adjustable free standing spool holder, the spacing of the bearings are a lot wider apart than many of the others holders out there which means the spool sits lower in the rollers meaning its a little harder for the spool to be pulled out of the stand.The only hardware you will need is...x4 608z Bearingssuper glueFiles to print....x1 base Ax1 base Bx2 side malex2 side femalebase A is printed upside down.Assembly is easy, run glue in the slots on the base them put a blob of glue on the end of bearing shaft of the side male then fit bearings on part and fit them into the base and repeat for the second half. i fitted some adhesive backed felt to the bases so it does not slip as easy.NOTE the sides fitting into the base slots are a tight fit so you may have to play with your x y compensation until it suits your setup.if you give this one a try and you like it give me a thumbs up, thanks