3D Printer Electronics Enclosure - Touch Screen, Mainboard, MOSFET, PSU, Raspberry, Fan.

youmagine

This is an electronics enclosure that doubles as a touch screen for Octoprint. Designed with the Anet A8 in mind, it should work with most printers. Electronic mounting points are available for: * Anet A8 main board * Original Anet A8 screen and controls * Two MOSFETs * Upgraded 30 amp power supply, plus the original Anet A8 PSU (the original uses one screw on top but can be secured with more if desired) * Two SD card slots for Anet and Raspberry via microSD to SD adapters * Light switch * 80mm cooling fan * 7-inch touch screen To build: Not much complexity is involved. Infill and layer height are up to the individual printer settings. All parts are laid out as printed, so feel free to position them however desired. They all fit on a 220x220 build plate. Print main body parts, then glue or plastic weld them together. The Lid and Front Panel parts screw into place. To achieve a contrasting outline for the Octoprint logo and edges, print that part with "First Layer Only" first, don't remove it from the build plate, then print the whole piece on top of it. Do the same for the Anet logo. Raspberry mounts underneath the back Lid. Octoprint Touch UI setup: I followed this guide to get everything working: https://github.com/BillyBlaze/OctoPrint-TouchUI/wiki/Setup:-Boot-to-Browser-(Jessie-Full)