3D Printer Calibration Tester

thingiverse

Human here with a tool that fine tunes overhangs at the exact 43 degree angle, utilizing an ellipse to verify filament retraction on two small pillars, checking for accuracy in both X and Y directions by testing sharp corners and complex curves while identifying warping. This is ideal to calibrate your print settings based on the specific type of plastic being used. If you're aiming for a faster print, reduce the size down as it took around one hour to complete this calibration tester. These are the printer settings I personally used on my MakerGear M2: Layer height: 1.7mm Fan speed: 100% during cooling Raft and Skirt features should be enabled Infill at 53% Leave support material turned off Print speed set at 4500 mm/min