3D Printer Calibration Parts

thingiverse

Here are some easy calibration models for fine-tuning your 3D printer. I print out the 1in x 1/8 disk and then measure it with calipers to get an accurate reading. The Infill model is solid inside, so I tested different infill densities to find the perfect balance between being open yet supportive enough for the dome's design. My Thin test simply involves a one-pass print test to check everything is working as expected. I use the ring calibration for concentric alignment because it helps me achieve precise prints every time. Support Test 1 is just a simple support density calibration, which I've found crucial in getting good results with my printer.