3D Printed Watercooled PC Case

thingiverse

I designed and built a custom 3D printable PC case from scratch. It's uploaded here if you're up for the challenge of printing it yourself. You can also check out my video showcase on YouTube at https://www.youtube.com/watch?v=DKSNKyu7UWE. The entire case required approximately 2.5 kilograms of filament to print. Here are the specifications for this custom PC case: Motherboard size: mITX (170mm x 170mm) Supported graphics card: Up to a maximum length of 280mm and a maximum of 2.5 slots PSU size: SFX, which is the same type as my Corsair SF750 power supply unit CPU air cooler: A low-profile air cooler that's no taller than 60mm Distro plate: Designed specifically for use with Lian Li PC-O11 Distro-Plate G1 Cooling features: * Two 120mm fans at the front, paired with a 240mm radiator * Two 120mm fans at the bottom, paired with another 240mm radiator The overall size of this custom case is 520mm wide, 460mm high, and 240mm deep when including the pump, feet, and side panels. Please note that I've only built this case as a water-cooled setup. The results may vary if you choose to use an air-cooled setup. Use these files at your own risk, and please be aware that I won't take responsibility for any property damage or injuries that may occur during the printing or assembly process.