3D printed RC truck V3: Single rear axle(Dual wheels setup)

thingiverse

Finally I can release the rear axle, it's been a long wait for these bearings so I could finally finish. The center differential needs just a tiny bit of polish then it should be ready to release, stay tuned! You can check out the assembly video for this over at my YouTube channel http://www.youtube.com/c/MrCrankyfaceProjects. Note that some filenames have an x at the end, which indicates how many you'll need of each one. Hardware Needed: * 7x M3x10 * 7x M3 nuts * 4x Counter-sunk M3 screws * 4x M3x16 * 1x 4mm rod, 18mm long * 6x 6700ZZ or equivalent bearings (15x10x4mm) For more V3 parts, check out my V3 collection on Thingiverse: http://www.thingiverse.com/MrCrankyface/collections/printed-rc-truck-v3. You can also find me at: * YouTube: http://www.youtube.com/c/MrCrankyfaceProjects * Instagram: https://www.instagram.com/mr.crankyface/ * 3D Hubs: https://www.3dhubs.com/malmö/hubs/mrcrankyface * Patreon: http://patreon.com/Mrcrankyface Print Settings: * Printer: + The Frankenstein + Rafts: No + Supports: No + Resolution: 0.2mm + Infill: 30% * Notes: + Everything should be printable without support except the rims, print them with support and the square socket upwards for best results. + I recommend 30-50% infill for the smaller parts and the axle housing.