3D printed RC aircraft model, CF-10C 'Dart'

cults3d

Here are some basic parameters of this model: Wing span: 930mm Take off weight should be controlled around 970g Wing area is approximately 0.17m^2 Airfoil used is NACA-25112 Recommended setup: 40A ESC is recommended for this model A 2306 motor with a 2400kv rating performs well The 5x4x3 propeller provides optimal thrust A 1300-1600mah 4s Lipo battery is required Flight videos can be viewed at the following links: https://www.youtube.com/watch?v=ur1IY8GNQqk https://www.youtube.com/watch?v=-P_UUdS791M&t=31s This model is a newer version of the 'Dart-1' design. The vertical stabilizers have been modified to resemble those on an F-22, and the additional fins on the bottom provide better protection for the frame during landing. The larger canopy and battery bay allow for a bigger battery and FPV gear to be installed inside. This relatively small frame is easy to maneuver, making it suitable for flying in tight spaces. The forward swept wing design provides excellent stall characteristics and a high L/D ratio, making this model an efficient FPV platform.