3D printed - International Woman's Day "pin" for buttonhole - "Venus Symbol"

thingiverse

This small wearable piece shows support for Women's Rights and other Women-related causes. If you use it, share your Make's and uses with us! Thanks and enjoy. Two versions are available: one with a helper disk and another without. With the helper disk version, I've added a small 0.2mm disk under the "button" part of the print to eliminate the need for a raft. This setup allows it to print just fine with only supports. The other version prints without a disk. The original TinkerCAD file is linked below and open. This design was created using Tinkercad, which can be edited online at https://www.tinkercad.com/things/j1Gmk3jZO0U. Learn more about the symbol used here: https://en.wikipedia.org/wiki/Venus_symbol. Print Settings: * Rafts: No * Supports: Yes * Resolution: 0.2 Notes: A small 0.2mm disk is added under the "button" part to eliminate the need for a raft, allowing it to print with just supports. After printing, remove the disk and supports, then put the wearable piece in a button hole.