3D PRINT READY!! Ruby Rose from RWBY

thingiverse

This print is ready to go and doesn't need any more fixing to be printed! 3D Print other RWBY models here: https://www.thingiverse.com/thing:2357481 Ruby Rose https://www.thingiverse.com/thing:2397963 Weiss Schnee https://www.thingiverse.com/thing:2447958 Blake Belladonna https://www.thingiverse.com/thing:2471634 Yang Xiao Long https://www.thingiverse.com/thing:2504153 Velvet https://www.thingiverse.com/thing:2753068 Nora https://www.thingiverse.com/thing:2846440 Zwei (dog) Join the Anime Figure group and share and print anime figures! As well as updates on what I'm doing next https://www.thingiverse.com/groups/animefigures Support me on Patreon! https://www.patreon.com/AnimuAnimu/posts This print already has all support material ready to go, DO NOT add support material. The support material that I already added to the file has tapered ends and easily breaks off, however be very careful removing, especially around the head. No cutting or gluing necessary. DO NOT PRINT WITH A RAFT OR SUPPORT MATERIAL There are THREE STL files included, print the 3DPrintReady FILE. I included files of the print without supports and one without the base if you want to add your own supports. Note a base is necessary or the model will tip over. It's a good idea to add some pauses toward the tip of the sickle so that the point has enough time to cool and doesn't end up all melted like mine. I included my Cura print settings if you were curious, however you should switch to like a .05 mm layer height and a slower print speed to make it look better. If I get around to it, I'll print it again at slower speed and post more pictures. I printed mine kind of fast. I did a bunch of smoothing in Meshmixer, so the STL file is quite big even after being 'reduced', so be patient! I only had black PLA on hand, I'm sure a white plastic will make the details show up better, especially in pictures, and won't leave white spots where the support material attached.