3D/BL touch mount for Anet A6

thingiverse

### Don't Forget To Post Your 'I Made One'!! ### Change Log UPDATE 17/10/21 : Added Picture And Instructions For Cabling. UPDATE 17/08/06 : Configurations Were Added. UPDATE 17/08/02 : Bootloader Was Reflashed, Marlinfw Was Reflashed, Let's Measure The Right Coordinates Now! UPDATE 17/07/30 : I Bricked My Printer While Changing Firmware...I'm Reflashing It With An Arduino As ISP. ## Configuration Of Course You Need: `#define BLTOUCH` #### Probe Offsets (You May Have To Adjust The Z Position To Your Own Probe Z Offset): ```c //ANET A6 With BLTouch/3D-Touch Front Mount #define X_PROBE_OFFSET_FROM_EXTRUDER -9 //X Offset: -Left +Right [Of The Nozzle] #define Y_PROBE_OFFSET_FROM_EXTRUDER -56 //Y Offset: -Front +Behind [The Nozzle] #define Z_PROBE_OFFSET_FROM_EXTRUDER -1.7 //Z Offset: -Below +Above [The Nozzle] ``` #### Probing Limits: ```c #define LEFT_PROBE_BED_POSITION (0 + MIN_PROBE_EDGE) #define RIGHT_PROBE_BED_POSITION (X_MAX_POS + X_PROBE_OFFSET_FROM_EXTRUDER) #define FRONT_PROBE_BED_POSITION (0 + MIN_PROBE_EDGE) #define BACK_PROBE_BED_POSITION (Y_MAX_POS + Y_PROBE_OFFSET_FROM_EXTRUDER) ``` You Can Also `#define PROBE_Y_FIRST` To Reduce Stress On Your Prototyping Wiring ;-). And If You Are Using [Octoprint](http://octoprint.org/), You Can Probably Disable The SD Card By Commenting Out: `#define SDSUPPORT`. ## Cabling: - *IDC 10 Pins* Connector 1 Of Both Genders : Wire 7 ; - *JST XH 3pins* Female ; - *Dupont 1pin* 1 Of Bot Gender. Then Follow The Colors Of The Wires On The Pictures. **Note:** Brown Goes To Black Too. ### Side Notes: I'm Using Only 3 Grid Points On A Linear Bed Levelling. I Am Printing On A Borosilicate Glass Bed, I Don't Know If More Points Are Needed.