360W Power Supply Cover and Mount

thingiverse

Power Supply Cover and Mount for 360 Watt Power Supply For my Anet A8 build on an AM8 frame, I needed to modify the screw positions to accommodate a 360 Watt power supply. In addition, I designed a cover for cables and integrated a power switch with fuse. I also created a version for a second round switch to control an LED strip. The printed version in the images is my installed setup, but this shared file is a beta version. On the pictured model, the distance between the cover and power supply was off by 5mm. Since then, I corrected this mistake, ensuring proper alignment. **Printing Instructions** - Print the mount flat on its back without supports. - The cover requires minimal supports; print it flat on its front, with the switch holes facing up. Supports are needed for the front section that houses the mounting holes for the front part. The back mounting holes have a chamfer to facilitate easy printing. **Note** The cover is designed to accommodate up to two screws in the back for mounting. However, if you want to run wires through the channel, you cannot use that mounting hole. In my case, it's mounted with one screw at the top and uses the middle and bottom channels to route wires to the mainboard.