34t MXL param idler

thingiverse

This object was designed and customized using Thingiverse's online design tool. The specifications used for its creation are outlined below. Base diameter: The outer dimension of the central circle is fixed at 24mm. Screw arrangement: The first choice involves where the screws should be placed relative to the axis. Options range from -1 to 9, which represent increasing numbers of clockwise and counterclockwise turns. Length of the toothed portion: This specifies how far the part extends along the rotation axis. Set it to any number between 2 and 12 inclusive. Positioning of belt idlers: You can opt to include an idler for driving belts around a fixed point in the design. Idlers are usually represented as positive integers from -5 to +5, signifying the location where the component is installed on either side of its associated drive mechanism. Belt retainer position: This is set with either a value greater than 1 (meaning that it must be placed before every motor) or less than or equal to zero (-5, indicating not to have any retention features). When turned down there would then remain no such retention components; otherwise their installation points would be located within range defined previously. Screw type and shape: Determine if these should come with straight heads that include six notches or cross-shaped profiles where twelve are present at their very top; three being above middle notch; lower three towards other side just like original thing showed originally. Decide here also whether each screw will simply rotate smoothly on circular surface once fitted inside appropriate hole provided here so make sense always good time spend there...