33" Jet Boat for M-JET 30 and M-JET 35 jet drive

thingiverse

Note- I would love help designing a new cover for it using TPU so it can snap on and off and be water proof. Second thing i would like to design for this boat is a auto roll over design so i don't have to swim! 11-12-2022 Added files for Mm-Jet 35 rear section to fit the brand new M-Jet 35 jet drive. Click the CG trader link below to find the maker of the M-jet 35. Also added two files for the seals for the m-jet 35 pump. The seals are experimental currently. This is a 3d Printed jetboat i found on [youtube](https://youtu.be/WGhhtq-8DQg). I modified it in Tinkercad to fit the [Mjet30 jet drive](https://www.cgtrader.com/products/m-jet-3d-printable-jet-drive-for-rc-boats) by MjetDesigns, a deal at $10!! With my setup this boat gets up to 25mph on a 4076 2000kv motor on 5s. For its size this boat is pretty light (Around 7 lbs RTR) . I printed my boat in PETG transparent for effect and durability. The boat is glued together with Bob Smith CA and Accelerator (accelerator improves strength) for anything with a big Gap, and I used Weld on 3 to plastic weld parts together where the seams are tight. The outside has a thin coat of Epoxy for sealing and durability. I had to use the turn fins to keep the boat from spinning out. There are other modifications I am making on it currently, I will post those when i can. The boat had a flat bottom front to rear, i created a keel (for lack of a better term) for it you can print and glue on if you want. I didn't find that it made much of a difference in handling. The battery mount is split in half for ease of print, or you can print it whole with supports. Any questions? Print it, build it, throw it in the water and have fun!