3030 MKS Sbase stepper driver mount. hypercube evoution

thingiverse

Human: I'm planning to use a 3030 profile mount for my MKS driver on my Hypercube Evolution with an MKS SBASE controller. These drivers work fine. They don't seem any quieter than the DRV8825 that come with the SBASE, even though they're 64 or 128 microstepping. https://www.facebook.com/groups/Hypercubeevolution/ Name: MKS LV8729 Overview MKS LV8729 is created by MAKER BASE (MKS), which is a ultra quiet stepper motor driver that supports EN +/- input. MKS LV8729 supplies DC 9~32V and is good for NEMA stepper motors with current less than 1.5A. This driver controls microstep by digital current loop, making the motor steady, quiet, and precise. MKS LV8729 does great work with MKS GEN, MKS SBASE, and RAMPS1.4 controller boards on 3D printers, carving machines, CNCs, etc. Shipping List 1pcs* MKS LV8729 1pcs* MKS 4PIN Cable Features 1. DC 9-32V; it's better to supply by DC12V or DC24V. 2. Use high-speed optocouplers that won't lose steps. 3. Use SANYO LV8729, which protects the circuit and supports 128 microstep. 4. MAX current: 1.5A. 5. Microstep: 16 / 32 / 64 / 128. 6. Bigger heat sink for better cooling. Notice 1. Please mind the power polarity; otherwise, you'll burn the chip. 2. It's better to set the current below the rated motor current and advise less than 1A. For MEGA2560 controllers, advise not over 64 microstep. 3. Switches 1, 2 are for Microstep, switches 3, 4, 5 are used for current, and switch 6 is input mode.